PTU Steampunk Forum Set

This tut was written July 26th, 2017 for those with a basic knowledge of psp.

I am using the awesome artwork of  Trinita.

The tube is called Gaby.

You need a license to use this art work. Please do not use without a license.

 You can find this art at the PFD Store  HERE

Supplies Needed

I used PSPX...but any of them should work.
PTU Scrap Viktorya by BLT Creates at PFD  HERE or Etsy: HERE

Available in both Full and Tagger Size
Wonderful kit for your Steampunk tagging fun.

Filters
Mura Meister Copies-Line
Tramage-Mo'Jellyfish

 Font of Choice, I used Onyx

Drop Shadow usually V2 H2 50 black

 *Remember to add your drop shadow as you go along*

Open a new image 600 x 250 for the Signature tag, paste
paper 4, take your crop tool and crop the paper.
Apply the filter Tramage-Mo'Jellyfish on the paper with these settings
0, 50, 45

Resize flower 1 to 25%, paste at the bottom so only the top half shows,
apply Mura Meister Copies-Line, duplicate, flip, adjust at the top.

Resize flower 4 to 25%, apply Mura Meister Copies to this one also, move below
the red flower and up just a bit, duplicate, flip, move so just a little is showing
below the red flower.

Resize the swirl to 25%,  flip, apply the Mura Meister Copies to this, move below
the metal flower layer just so a little bit of it shows.

Resize cluster 2 to 35%, paste at the bottom just so the tip of the wing touch
the bottom.

Resize the Deco Gear to 20%, paste it on the top layer at the bottom on one side
of the clock, duplicate, mirror.

Resize your tube to 75%, paste on one side, duplicate, mirror, change the
blend mode to Screen on both, don't merge just yet, you might need to
adjust them along the way.

Resize your tube to 60%, being on the top layer, paste off center, now go
back to your other tubes and adjust them behind the top one the way you like.

Take your selection tool, draw out a rectangle, add a new layer, fill with a color of
choice or use the one I used, #671e2a, change the blend mode to Soft Light.
Go to Effect, Edge Effects-Enhance more on both of these.

Type out Steampunk several times until it is across the rectangle, adjust,
I used Onyx font, set on 26 pixels, and bold pushed in
or the letter B on your psp tool bar. 
Add a light gradient glow, then merge visible.

For your Avator
Open a size that you prefer, mine is 200 x 200, copy your Signature tag,
paste, resize to 85%, adjust, merge visible.

For the frame on both I used AAAFrames-Foto Frame, width at 3.

Add your copyrights and name on both tags.

That's it

Hope you enjoyed doing my tut.