FTU Kitty in the Pot-3 Piece Set

This tut was written May 21st, 2018 for those with a basic knowledge of psp.

I am using the awesome artwork of Laguna

The tube is "Kitty in Pot " 

You need a license to use this tube, do not use without a license.

You can find this tube at PFD store  HERE

I used PSPX...but any of them should work.

FTU kit Springtime Mini by Tasha's Playground  HERE
This is an older kit but it seem to fit this tube perfectly.
Check out the rest of the blog HERE

RD Mask 711  HERE
Check out the rest of the blog HERE

Filters
xero-Clarity
penta.com-Dot and Cross (Optional)

Font of choice,  I used Mariabella

Drop shadow is usually V-2 H-2 Black, 50, 5, use what you prefer.

Let's get started

*Remember to add your drop shadow as you go along*

Open a new image 800 x 800

Paste paper 3, apply your mask, delete, merge group.
Paste paper 4 next and apply the same mask, delete, merge group, resize 
smaller to 98%, then merge down.

Paste frame 3 to the left, click inside with the magic wand, expand by 5,
paste paper 4, invert, delete, select none.

Resize your tube to 30%, paste on the right on the frame layer.

Paste the flower pot at the lower left below the tube layer so the ladybug looks
like she is coming out of the pot.
Paste the grass element on the right behind the tube, duplicate, mirror.
Resize the leaves to 70%, paste at the bottom right under the tube, duplicate,
mirror, duplicate again, move back toward the center more.

Resize flower 3 and 2 to 40%, paste at the lower left by the pot, duplicate
the green flower, mirror, move below the tube on the right. 
Duplicate the pink flower, mirror, move to the upper right on the frame.

Resize the butterflies to 55%, paste at the upper right being on the top layer,
duplicate, mirror, erase the larger butterfly.

Resize the kite to 90%, paste at the upper left below the tube.
Paste the ladder on the right above the frame layer behind the blades of grass.
Resize heart to 65%, paste on the flower pot on the left.

Add any other elements that you would like, make it your own.

Once happy with your tag, close off any background used, 

crop your tag to make sure no shadows or anything on the edges, merge visible.
Resize your tag, then apply the xero filter-Clarity. (Optional)
Then apply the penta.com-Dot and Cross either before you add the name or after.

Add your name and copyright, save.

If you would like to do a Signature tag
Open a new image 600 x 250, fill with #e4f0dc, copy and paste your tag, 
adjust how you like, merge visible, apply a frame of choice.
I used AAAframe-Foto Frame, width on 2 and I changed the opacity to 65.

For the Avator
Open a size of choice, mine is 175 x 200
Copy and paste the signature tag, resize to 85%, move to the right a bit,
add the same frame as the sig tag.

That's it

Hope you enjoyed doing my tut.