Monday, April 2, 2018

PTU Punk Rock Babe


This tut was written April 2nd, 2018, for those with a basic knowledge of psp.
I am using the awesome tube by artist Di Halim
Tube is called"Punk Babe"
 You need a license to use this art, please do not use without a license.
You can find the tube at S&CO  HERE

Supplies Needed
I used PSPX...but any of them should work.
PTU kit  Rock Gawds by All Dolled Up! 
HERE or HERE or HERE
Long live rock N roll! Party hardy, rock n roll!
With this kit that's just what you can do! With 140 Elements and 20 Papers
this kit will have you banging your head til the early morning
MizTeeques Mask_087  HERE
Check out the rest of the blog HERE

Font of Choice, I used Agra Axera

Drop Shadow usually V2 H2 50 black
 *Remember to add your drop shadow as you go along*

Open a new image 800 x 800
Paste paper 19, apply your mask, delete, merge group.

Resize your tube to 20%, paste to the right more.

Resize element 46 to 55%, paste on the left below the tube layer and up 
how you like.
Resize element 76 to 45%, paste under the tube like she is sitting on it.
Paste element 6 below the wordart on the left.

Resize element 74 to 25%, paste at the lower left being on the top layer.
Mirror element 71, paste on the light at the lower left.
Resize element 13 to 25%, paste at the lower right by the foot of the tube.

Resize element 34 to 20%, paste at the lower right behind the leg of the tube,
duplicate, take your Pick tool, hold the shift key and drag one side down and then the
other until it is as flat as you like, move to the left under the hat, duplicate, move
over a bit.
Paste element 38 at the bottom below the mask layer, adjust everything to fit 
on the floor better now.

Resize element 18 to 85%, mirror, paste below the tube on the right.
Resize element 30 to 50%, paste on the mask layer and up.
Paste element 86 below the tube and adjust how you like.

Resize element 65 to 50%, paste at the upper right below the tube, add a white 
drop shadow, duplicate, mirror, move down on the left below the 
drums layer, duplicate again, mirror, adjust on the right.

Paste element 54 at the top below the disco ball.
Resize element 136 to 70%, free rotate to the left at 10 degrees,
mirror, paste on the left just above the drums.

Add any other elements you would like to add.

That's it
Hope you enjoyed doing my tut.

No comments:

Post a Comment