This tut was written July 11st, 2022 for those with a basic knowledge of psp.
I am using the the artist PinUp Toons
Tube is 264-3
You need a license to use this tube, please do not use without a license.
You can find this this tube at CDO HERE
I used PSP2020...but any of them should work.
Drop shadow is V -1 H -4, 50, 10, or use what you prefer.
Let's get started
*Remember to add your drop shadow as you go along*
Open a new image 800 x 800, paste paper 7, resize the mask larger to 120%,
apply your mask, delete, merge group.
Resize element 2 to 75%, past to the right more.
Resize element 27 to 75%, paste on the left above the cottage, duplicate, resize
smaller to 75%. move to the right behind the cottage.
Paste element 12 at the bottom being on the top layer.
Resize element 13 to 50%, mirror, paste below the fence.
Resize your tube to 60%, paste above the fence to the left.
Resize element 17 to 40%, paste at the lower right above the fence.
Resize element 16 to 35%, paste on the chair.
Resize element 24 to 20%, paste at the bottom above the chair.
Resize element 4 to 15%, paste on the basket.
Resize element 1 to 25%, paste at the lower right above the chair, move the cat so
the tail is over the blanket.
Resize element 18 to 15%, paste above the blanket.
Open paper 7, paste mask 78, select all, float, defloat, invert, being on the paper layer,
move the paper layer to where you like, delete, select none, delete the mask.
Copy the paper and paste at the bottom above the fence, duplicate, mirror.
Resize element 5 to 25%, paste at the bottom left above the tube.
Resize element 6 to 50%, paste on the left below the tube.
Go back to the flower on the blanket, duplicate, mirror, duplicate again, move to
the right more behind the watering can.
Resize element 27 to 25%, paste on the trellis on the left.
Resize element 3 to 20%, paste at the bottom by the leg of the tube, duplicate, mirror.
Resize element 19 to 15%, paste at the lower left below the flower, duplicate, mirror,
duplicate a couple more times, move where you like.
Paste wordart 1 at the bottom, being on the top layer, change the blend mode to
Luminance, duplicate, merge down.
Add any other elements that you would like, make it your own.
Always readjust your mask and elements how you like them before you
merge your tag, resize, sharpen.
Crop your tag to be sure no shadows or lines are on the edges.
Then add your copyright and name.
That's it
Hope you enjoyed doing my tut.
No comments:
Post a Comment