PTU Immortal Rose

 

This tut was written August 12th, 2022 for those with a basic knowledge of psp. 

I am using the the artist Eny Guerrero 49-2

You need a license to use this tube, please do not use without a license.
You can find this tubes at CDO HERE  

I used PSP2020...but any of them should work.

PTU ScrapLRD_ImmortalRose-mini by LeReina Designz HERE

This kit has 36 elements, 6 papers, 5 frames and 1 wordart

Mask of choice, I used Miz Teeques Mask 354 HERE

Check out the rest of the Blog HERE

Font of choice, I used Libertinage

Drop shadow is V -1 H -5, 50, 10, or use what you prefer.

Let's get started

*Remember to add your drop shadow as you go along*

Open a new image 800 x 800, paste paper 1, apply your mask, delete, merge group.

Paste frame 1 center.

Paste element 35 above the frame a little to the left.

Resize element 10 to 90%, paste at the lower left below the gray frame, duplicate,

mirror.

Paste element 27 being on the top layer, move up a little.

Resize element 24 to 75%, paste on the left, duplicate, mirror.

Paste element 2 on the left above the skulls, duplicate, mirror.

Resize your tube to 65%, paste below the rose trellis.

Resize element 3 to 50%, mirror, paste on the left above the tube.

Resize element 13 to 50%, paste at the bottom above the tube layer, duplicate, 

mirror.

Resize element 9 to 50%, paste on the right below the flowers.

Resize element 26 to 30%, paste at the bottom below the flowers that are on the right.

Resize element 8 to 35%, paste at the bottom.

Resize element 21 to 40%, paste toward the bottom above the tube behind the cat.

Resize element 20 to 50%, paste on the left below the flowers.

Resize element 34 to 30%, paste below the arch behind the tube.

Resize element 33 to 50%, mirror, paste at the upper left, duplicate, mirror,

move down a little, erase the outside ones.

Resize element 14 to 30%, paste on the crystal element on the right.

Sharpen a few times to make it show up better.

Resize element 12 to 20%, paste below the cat in the box at the bottom.

Resize element 30 to 10%, paste on the arm of the tube.

Being on the top layer, paste your wordart toward the bottom.

Add any other elements that you would like, make it your own.

Always readjust your mask and elements how you like them before you

 merge your tag, resize, sharpen.

Crop your tag to be sure no shadows or lines are on the edges.

 Then add your copyright and name.

That's it

Hope you enjoyed doing my tut.