Monday, December 4, 2017

PTU Ice Princess


This tut was written Dec 4th, 2017, for those with a basic knowledge of psp.
I am using the awesome artwork of  LysIsange
The tube is Awesome, it is called "Ice Princess"
You need a license to use this art work. Please do not use without a license.
You can get this tube at S&CO Store  HERE

Supplies Needed
I used PSPX...but any of them should work.
PTU matching kit Ice PRincess by A Lil Mz Brainstorm  HERE
Dragonfly Mask 018  HERE
Check out the rest of the blog HERE

Font of Choice, I used StarmiX

Drop Shadow usually V2 H2 50 black
 *Remember to add your drop shadow as you go along*

Open a new image 800 x 800
Paste paper 4, apply your mask, delete, merge group, duplicate,
merge down.

Resize element 11 to 70%, free rotate to the left at 10 degrees, duplicate, mirror,
adjust. Click inside with your magic wand, expand by 5, paste paper 1,
invert, delete, keep selected.
Resize your tube to 65%, paste in one frame, delete, mirror the tube, then paste
in the other frame, delete, select none. Change the blend mode to
Luminance (L)

Paste element 112 at the bottom, move to the left, duplicate, mirror.
Resize your tube to 35%, paste in the center above the frame layers.

Resize element 35 to 20%, free rotate to the left at 90 degrees, paste at the bottom
in front of the tube.
Resize element 34 and 36 to 20%, paste at the bottom by the other ornament.
Paste element 82 below the paper layer of the frame on one side, duplicate, mirror.
Resize element 2 to 50%, paste on the left below the tube layer.
Resize element 95 to 45%, paste on the lower right.

Paste element 14 at the bottom on the snow edge, being on the top layer,
duplicate, mirror.
Paste element 40 on the mask layer and move up so just a little shows
above the frame, duplicate, move over some.
Paste element 106 on the tube layer.
Resize element 84 to 25%, paste by the ornaments at the bottom
Resize element 109 to 30%, paste by the bear, duplicate, move to the left of
the ornaments, duplicate, mirror, move below the bear layer.

Add any other elements you would like to add.

Crop your tag to be sure no stray shadows are on the edges of your tag.
Once happy with it all, close off any backgrounds, merge visible.
Resize first, then add your copyrights and name.

That's it
Hope you enjoyed doing my tut.




No comments:

Post a Comment